Theinterfacing between MSP430 and the 7 segment display is done using a parallel interface ie i am using 8 data lines to control the 7 segments + decimal Point on the Display. The Code provided will display the numbers from 0 - 9 and alpha numeric Characters like A,b,C ,d, E, on the 7 segment display. The 7 segment Display used in
7Segment Display and Registers Memory Question 2: Direction: Given question consists of two statements, one labeled as the 'Assertion (A)' and the other as 'Reason (R)'. You are to examine these two statements carefully and select the answers to these items using the codes given below. Theresults display the output of the 7-segment display with Arduino Uno. It will show a counting starting from 0 to 1200 to demonstrate all four digits. At the end of the code, it will run again from the start. The results are not the seconds, it’s just the counting made with the for loop with a delay of 100 milliseconds. Unlikethe 74HC595 shift register, we don’t need to control each digit of 7-segment display individually by adding delay. We just send data 7-segments and seven-segment control data. It has a built-in BCD to 7-segment decoder. Most importantly, it has on-chip 8×8 RAM which we can use to store display codes of digits that we want to SevenSegdisp (11, 7, 3, 5, 6, 10, 2); const int numOfDigits = 1; int digitPins [numOfDigits] = {1}; void setup () { disp.setDigitPins (numOfDigits, digitPins); } void loop . 366 368 335 340 236 93 123 160 52